HIGH-SPEED 3-IN-1 FAST USB ARM JTAG, USB-TO-RS232 VIRTUAL PORT AND POWER SUPPLY 5VDC DEVICE (SUPPORTED BY OPENOCD ARM DEBUGGER)
IMPORTANT NOTE: From MARCH 2022 the ARM-USB-OCD-H design is updated in newer smaller plastic box. The USB connection is USB-C type. All other features are same as before. We keep old pictures of ARM-USB-OCD-H as reference.
FEATURES
- First on market three-in-one USB JTAG debugger – offers JTAG + RS232 (full modem signals supported) port + power supply all in one compact device
- Adds virtual RS232 port to your computer with all modem signals like: DTR, DSR, DCD, RTS, CTS, Rx, Tx
- Debugs all ARM microcontrollers with JTAG interface supported by OpenOCD
- High speed USB 2.0 with lower latency time, RTCK adaptive JTAG clock up to 30Mhz and higher throughput achieve x3-x5 times faster programming speed than ARM-USB-OCD
- Auto-detected powering to your target board with up to 200mA at 5V
- Uses ARM’s standard JTAG connector (2 rows × 10 pins at 0.1” step)
- Supports ARM targets working in voltage range 1.65 – 5.0 V DC
- Supports adaptive clocking RTCK
- Able to power a target board via a standard DC barrel jack; cable for the external powering included – 2.1×5.5x14mm female connectors at both ends
- Supported by the open-source community and OpenOCD debugger software
- Downloadable Windows installer for full featured and open source tools as alternative to the commercial ARM development packages: GCC C compiler, OpenOCD debugger and Eclipse IDE.
- Works with IAR EW for ARM via GDB server
- Works with Rowley Crossworks IDE
- Works with CooCox IDE
- Supported in Windows, Linux and Mac
- Dimensions 50×40 mm (2×1.6″) + 20 cm (8″) JTAG cable – ribbon cable included
DOCUMENTS
HARDWARE
SOFTWARE
- OpenOCD for Windows
- Additional resources: tutorials, instructions, demo software, customer projects, older drivers and more might be found at the wiki page: ARM-USB-OCD article
