MAX3232 RS232 to TTL Converter Module
This is a small handy module for rapid prototyping projects requiring RS232/PC interface to robotics and microcontroller based projects using 3.3V or 5V TTL logic. This module converts signals between RS232 voltage levels and TTL voltage levels.
Features:
- Working voltage:3.3V-5.5V
- PCB Size : 32mmx28mm
- High speed, built in SMD MAX3232 device fitted.
- Supports Data Transfer upto 115kbps or even higher in short bursts.
- Works with PCs or Laptops.
- Tested with microcontroller UARTs e.g. Microchip PIC16F877 and Atmel AVR (ATMEGA8515) devices.
- Selectable +3.3V or +5V signals levels at the TTL level (single 3.3V or 5V supply required via header).
- Status LED (D1)
- It can be used with Microchip PIC, Atmel AVR, STC MCU, NXP MCU, Renesas MCU,STM32 MCU and many other such micros.
- Also used in radio modification, XBOX360 flash, vehicle detection, phone flash, GPS , hard disk repair
- Port: TX RX VCC GND
TTL Connections Pinout:
Pin 1: VCC(+) – this pin requires 3.3V (or 5V for 5V TTL logic targets) to be supplied to the board for power.
Pin 2: RX – MAX3232 ROUT1 – This is actually a TTL output – this pin is usually connected to the RX pin of the UART in a microcontroller.
PC Serial Port RS232 level converted from TTL level input
Pin 3: TX – MAX3232 DIN1 – This is actually a TTL input – this pin is usually connected to the TX pin of the UART in a microcontroller.
PC Serial Port RS232 level converted to TTL level output
Pin 4: GND – this pin is the ground pin. This pin is usually connected to the 0V rail of the application hardware. Fully assembled.
Related information:
ASCII Serial Port Crib Sheets
MAX3232 – RS232 TTL IC Data sheet
